在线客服
客服热线
13813503791
客服组:
在线客服
服务时间:
8:00 - 17:30

PRODUCTS CATEGORIES

产品分类

全国热线电话

NATIONAL HOTLINE

 

13813503791(朱建新)

18961176182(姜爱琴)

 

全国热点邮箱
OUR MAILBOX

 

office@keyuan-cn.com

 

公司地址
COMPANY ADDRESS

 

常州市金坛区经济开发区河头工业园薛庄桥

 

常州市金坛科苑电器有限公司

COPYRIGHT © 2020 常州市金坛科苑电器有限公司 苏ICP备11079344号 网站建设:中企动力 常州
手机(Phone):13813503791 朱建新 18961176182 姜女士
电话(TEL):+86-0519-82526182 +86-519-82526183  客户反馈

关于我们

技术专栏
高频感应加热电源设备操作维护注意事项

1. 准备
 1.1 检查电源是否正常、导线连接是否牢固、感应圈匝间有无短路、有磁块的要注意其位置是否合适。
 1.2开水泵并检查冷却水流量是否正常、有无滴漏水情况。

2. 操作
 2.1 合上电源开关(进线开关及机器后部开关),等待5秒钟左右再拨动面板上的控制电源开关,观察面板上电源指示灯亮否。
 2.2 将电位器旋钮调至适当位置(工件不变时,电位器位置不变)根据不同的加热情况,参照使用说明书选择三种控制方式的其中一种进行操作。

3. 维护
 3.1 设备应有专人操作和保养,他人不得随意操作。
 3.2 应确保冷却水池(桶)内清洁,不得有杂物、污垢,每六个月要对机器水路进行一次清洗,除去水管内水垢,具体做法是将25kg左右的盐酸倒入塑料桶中,然后将水泵上的进水管和出水管一并放入塑料桶中,关闭机器电源,单独开启水泵运行15分钟,使盐酸在水路中循环流动,可以除去水垢。以避免因水垢堵塞水路、水流量降低而引起机器过热及水管涨裂。
 3.3 设备应注意防潮和防尘,阴雨天开机前要用电吹风机进行防潮处理,热处理冷却水不可飞溅到机器上。
 3.4特别要注意周围环境有无导电粉尘或腐蚀性气体(如酸雾),这些导电和腐蚀性气体会严重影响设备的正常工作并经常损害设备内的电子元件.
 3.5 应注意使用环境的条件,室温不超过35℃,空气湿度不超过90%,否则应加装通风风机。
 3.6 冬天室温低于0℃时,一旦停机不用应将感应圈拆卸,并放掉水泵及机器水管中的冷却水,以免因结冰而损坏水泵及机器内器件。
 3.7 应特别注意机器内外冷却水管是否因移动而卷曲(水管卷曲将使水流量减小),严重影响冷却效果,导致机内功率器件损坏。


 
1. Prepared
1.1 Power check whether it is normal, wire connection is strong, whether induction loop interturn short, we should pay attention to the magnetic block the suitability of their location.
1.2 a pump and check whether it is normal for the cooling water flow, whether drip water situation.
2. Operation
2.1, a power switch (switches and machinery into the back line switch), waiting to pick about 5 seconds on the control panel power switch, power indicator on the panel observed-not.
2.2 potentiometer knob will be transferred to an appropriate location (workpiece unchanged, the potential for the same position) under different heating, light Manual control options are one way to operate.
3. Maintenance
3.1 The equipment should be free operation and maintenance, operation and not arbitrarily.
3.2 should ensure that the cooling pond (barrels), cleaning, there must be no debris, dirt, every six months to carry out a sea of washing machines, water pipes, to remove scale, it would be specific about 25 kg of hydrochloric acid into the plastic bucket, then on the pump inlet and outlet pipe in plastic buckets together Add to the closure of machine power, a separate 15-minute run to open pumps, hydrochloric acid in the sea in circulation, remove furring. So as to avoid fouling plug waterways, and reduce the water flow caused water pipes to overheat and crack up.
3.3 The equipment should pay attention to dust and moisture-resistant, rain days before rebooting use a hair dryer moisture-proof handle, heat treatment of the cooling water splashing on the machine.
3.4 Special attention should be paid to whether the surrounding environment conductive dust or corrosive gases (such as acid mist), conductive and corrosive gases will seriously affect the normal operation of equipment and often damage electronic components in the equipment.
3.5 should pay attention to the use of environmental conditions at room temperature not exceeding 35 ℃, air humidity less than 90%, it shall be the installation of ventilation fan.
3.6 winter temperature below 0 ℃, no downtime once induction loop should be demolished, pumps and machinery and release them in the cooling water pipes, so as to avoid damage due to ice machines, pumps and devices.
3.7 should pay special attention to whether the machines due to internal and external cooling pipe mobile and curly (curly pipes will reduce the water flow), which has seriously affected the cooling effect, resulting in damage to power devices in the machine.